Page 2 of 3
Line Input Specs (without Red-supplied special cables)
- Input impedance: 600 ohm
- Full scale input level: +8.2 dBu (2.0 V rms)
- Nominal input level (for 20 dB headroom): -11.8 dBu (200 mV rms)
Line Input Specs (with Red-supplied TA3-XLR padded cables)
- Input Impedance: 2000 ohm
- Full scale input level: +19.4 dBu (7.2 V rms)
- Nominal input level (for 20 dB headroom): -0.6 dBu (720 mV rms)
Line Inputs (with or without Red-supplied cable)
- Frequency response: flat, -2 dB @ 20 kHz, -2 dB @ 8 Hz, referenced to 1 kHz response (see graph)
- THD+N: 0.01% (22 Hz-22 kHz BW) best case, input to output at +5 dBu input, padded cable (see graph)
When the inputs are driven without equal voltage on each leg of the connection (impedance-balanced sources), the THD+N starts increasing 6 dB sooner than when driven with equal voltages. The chart above shows the THD+noise with impedance-balanced sources. The chart below shows THD+noise driving both pin-2 and pin-3 with signal.
- Dynamic range, input to .WAV file, best case: 89 dB (flat weighting, 22 Hz-22 kHz), 91 dB (A-weighting), 14.8 bits equivalent
- Dynamic range, input to analog output: 95 dB (flat weighting, 22 Hz-22 kHz), 97 dB (A-weighting), 15.8 bits equivalent
Analog Outputs:
- Full scale output level: +8.2 dBu (2.0 V rms)
- Nominal output level (for 20 dB headroom): -11.8 dBu (200 mV rms)
- Output impedance: 200 ohms
Headphone Output:
- Full scale output level: +2.2 dBu (1.0 V rms)
- Nominal output level (for 20dB headroom): -17.8 dBu (100 mV rms)
- Output impedance: <10 ohms